When equipment fails and the question becomes why, the answer has to survive challenge. An insurer needs a technically sound root cause and a quantified basis for the loss. Counsel needs an opinion that holds under cross-examination. Neither is served by a plausible theory.
From our Vancouver office we investigate electrical and mechanical failures for insurers, brokers, adjusters and legal counsel across British Columbia.
What we do
Root cause investigation. Electrical and mechanical failure analysis, using measurement and analysis rather than inference from damage patterns alone.
Electrical fire cause. Whether wiring, connections, distribution equipment or an appliance caused or contributed to a fire. See forensic electrical engineering.
Evidence preservation. Guidance on securing and documenting failed equipment before it is disturbed, which is frequently the difference between a defensible finding and an unprovable one.
Quantified basis of loss. Establishing not only what failed but what the failure mechanism implies about scope, causation and contribution.
Excluding candidate causes. As much of the work as identifying the actual one. A finding that has not eliminated the competing explanations will not survive scrutiny.
Expert reporting. Written so a decision-maker who is not an engineer can follow the finding, with the standards relied on cited by edition. Every deliverable is reviewed by a second engineer before it is issued.
Remediation and prevention. Where the client wants the failure not to recur — see remediation engineering.
Independence
An engineer retained to find a particular answer is worth nothing to the party retaining them, because the opposing expert will say so. We report what the evidence supports, including when that is unhelpful to the retaining party's position. That is the only basis on which forensic work has value.
Where our forensic work concentrates
Electrical failure and power quality are our strongest forensic ground — harmonic distortion, transient overvoltage, resonance, protection coordination failure, and the interaction between standby generation and sensitive loads. See forensic electrical engineering for what we investigate and how an investigation runs.
Selected work
Unit substation failure investigation — medium-voltage service entrance — A unit substation fault traced to how its secondary conductors were installed. Later damage to the transformer was identified as a separate cause.
Transformer failure investigation — industrial distribution system — A recently commissioned transformer failed on re-energisation and tripped the site's main substation. Relay event data placed the fault in the transformer, teardown established the cause, and the protection design was excluded.
Flood causation assessment — multi-unit residential building — A fixture's overflow was measured, found smaller than the reviewed submittal, and shown by calculation and code review to be a discrepancy and not the cause.
Forensic power quality investigation — 24.9 kV campus facility — Retained on an insurance claim after ten months of recurring VFD failures. Root cause established as harmonic distortion exceeding IEEE 519 limits, with the standby generator's high source impedance amplifying distortion three- to four-fold. A prime suspect — the site's power-factor-correction capacitor bank — was investigated and excluded with logged evidence.
Sectors
Insurance and legal · Industrial — mining and manufacturing · Commercial and architectural · Healthcare and institutional
Talk to us about a claim
Tell us what failed, when, and what has been preserved.
