Skip to content

Service

Mechanical engineering

Mechanical engineering for industrial, commercial and institutional facilities — HVAC, plumbing, fire suppression and process mechanical for year fifteen.

Mechanical systems are where a building's operating cost is decided. The equipment selected during design sets the energy bill, the maintenance burden and the replacement schedule for the next two or three decades — and by the time an owner feels the consequences, the design team is long gone.

We design on the assumption that we will be judged by how the facility performs in year fifteen, not at substantial completion.

Scope of work

HVAC design. Heating, cooling and ventilation system design, load calculations, equipment selection, and distribution layout. We size to the building's real operating profile rather than to a worst-case assumption that leaves the owner running oversized equipment at part load for its entire life.

Energy and ASHRAE compliance. Intent-by-space documentation, ventilation rate compliance, and energy modelling support for code and incentive-programme requirements.

Plumbing. Domestic water, sanitary and storm design, fixture and pipe sizing, and service coordination.

Fire suppression. Sprinkler and suppression system design, hydraulic calculations, and coordination with fire alarm and life-safety systems so the sequence of operation is consistent across disciplines.

Mechanical equipment and motor schedules. Complete equipment schedules and motor lists coordinated with the electrical design, which is where mixed electrical-and-mechanical firms should earn their keep and frequently do not.

Building systems integration. Controls strategy, commissioning support, and the coordination work that determines whether the systems actually operate the way the drawings say they will.

Existing building assessment. Condition assessment, capacity verification and remediation design for buildings being renovated, repurposed or brought up to current code.

How we work

Reviewed before it leaves. Every deliverable is reviewed by a second engineer before it is issued. Errors caught in our office cost hours; errors caught during construction or at plan review cost weeks and land on someone else's schedule.

Electrical and mechanical under one roof. Most of our projects carry both disciplines. Motor schedules, equipment loads and control interlocks are coordinated internally rather than across a gap between two firms — which removes an entire category of RFI.

Integrated with the project team. We work inside the owner's, architect's or EPC's delivery model rather than alongside it.

Sectors we work in

Selected work

Phased cooling replacement with heat pumps at an operating care facility — Failing cooling on four air handling units replaced with heat pumps in phases, the building open throughout, and the controls set to run the heat pumps ahead of the gas plant.

Replacement cost evaluation for district energy transfer stations — Mechanical and plumbing systems in a district energy utility's energy transfer stations evaluated for complete replacement cost, to set the insurance coverage.

Post-fire electrical and mechanical restoration at a greenhouse producer — Boilers, variable frequency drives, piping and controls restored alongside the electrical distribution after a fire, on the owner's behalf.

Expertise

Building systems design · Fire alarm systems · Load flow and motor starting studies

Talk to us about your project

Send us the scope and constraints and we will tell you plainly whether we are the right firm for it.

Start a conversation

Talk to us about your project

Send us the scope and the constraints. We will tell you plainly whether we are the right firm for it — and if we are not, we will say so.