Skip to content

Sector

Commercial and Architectural

Engineering that protects design intent through CD, permit and contract administration — for architects of record, interior architects and owner's reps.

Building plans on a desk

Architects do not choose an engineer on scope; most firms list the same scope. They choose on whether the engineer will protect the design intent through construction documents, permit and contract administration.

The failure modes are familiar. The engineer who routes a main run through the feature ceiling. The one whose drawings generate forty RFIs and turn contract administration into your problem. The one who, when the budget tightens, quietly value-engineers away the thing the whole scheme was built around, and tells you at the site meeting.

Protecting design intent

Design intent is protected by asking early, not by defending late. We want to know at schematic which moves are load-bearing to the design — the exposed ceiling, the lighting rhythm, the sightline that cannot carry a duct or a conduit — so we route around them while routing is still cheap.

When a constraint makes something genuinely undeliverable, you hear it from us at the point where you still have options, with alternatives attached. Not at CA.

Through permit

We design to be defensible at the AHJ. Complete calculations, documented assumptions, and drawings that answer the reviewer's questions before they are asked. Permit delays on commercial fit-outs are rarely about the design being wrong — they are about the submission being incomplete.

Through contract administration

This is where an engineer earns or destroys their reputation with an architect. Every deliverable is reviewed by a second engineer before it is issued, which is why our drawings survive contractor RFIs and plan review without redesign. The point of that is not internal quality theatre — it is that coordination errors get caught in the office rather than surfacing as RFIs that land on your desk during construction.

We answer RFIs and carry out site review ourselves. The engineer who sealed the drawings is the engineer who responds.

What we do here

  • Electrical and mechanical design for commercial fit-outs and ground-up commercial buildings
  • Lighting design, photometric analysis and control strategy
  • HVAC and building systems design and coordination
  • Power distribution, service capacity assessment and tenant metering
  • Fire alarm design and life-safety coordination
  • Permit support and AHJ submissions
  • Contract administration, RFI response and site review

Both disciplines run in-house, so mechanical equipment loads, electrical capacity and control interlocks are coordinated internally — which removes an entire category of RFI before it reaches you.

Selected work

Chilliwack UPC — Commercial project delivered with the architect of record.

Brewery and distillery portfolio — A run of production-and-hospitality projects where process loads, ventilation and public-facing design had to coexist in the same building.

Expertise

Building systems design · Fire alarm systems · Lighting design · Service connections and upgrades

Talk to us about your project

Send us the drawings at whatever stage they are at. We will tell you where the engineering pressure points are before you are committed to them.

Start a conversation

Talk to us about your project

Send us the scope and the constraints. We will tell you plainly whether we are the right firm for it — and if we are not, we will say so.